Great for hanging Drape Panels or banners. Most affordable telescoping drape support model. Steel hook-ends held into place with one rivet on each end. This telescoping Drape Support is available in three popular length and is a lower cost alternative to our Premier Drape Support.  This is a two piece telescoping rods that adjust using a button stop to different lengths, giving you the flexibility to work within your design space.  Our most popular size is our 6′ – 10′ support (often called Crossbar or Slider-bar) as most people design their Pipe and Drape set-ups using 10ft increments. If you are planning on hanging heavier drape like Topfinger Performance Velour, consider sizing up your Drape Support so you can get more of a double wall support when hanging your drape. This drape support features a steel hook end cast in plastic and is held into place with one rivet on each end. Our drape supports are designed to hold the distributed weight of fabric up to the weight of the steel bases that support the backdrop frame; so for 8’H, which typically uses 10lb bases, I would say that a 6-10‘ adjustable drape support can support 20lb of DISTRIBUTED FABRIC WEIGHT at 8‘ H. If you choose to hang anything besides fabric drapes, then we cannot advise as to the weight capacity of the drape supports, though we understand, of course, that sometimes pipe and drape is used in ways different from its intended purpose. The Topfinger Difference Steel hook ends, cast in black plastic, held into place with one rivet on each each Hook-end has a curvature that mate up with the curvature of the upright High-Strength, anodized aluminum Smaller buttons makes for quick transition when telescoping Punched, cut, and riveted in our factory, ask us if you need customization to any of our standard sizes Size is as follows: 3′ – 5′ drape support  4′ – 7′ drape support  5′ – 8′ drape support  6′ – 10′ drape support  7′ – 12′ drape support 8′ – 14′ drape support 9′ – 16′ drape support Other sizes are available